One of the best solutions to energy verses output for most home gardeners is to use outdoor light for flowering and use continuous light indoors for germination and vegetative growth. This will take advantage of the natural light/dark cycle and cut your energy use in half compared to the same operation indoors.

A small greenhouse can be built of Filon fiberglass or PVC sheets that is innocuous and looks much like a storage shed or tool shed so it's not likely to raise suspicions. In fact, a large shed of metal or plywood can be modified with a luminous roof of PVC, glass, fiberglass or plastic sheet, and some strains that do not require a great deal of light will grow well. Such a shed will discourage fly-by sightings and keep your business your own! It also allows you to keep out rats and gophers, keeps out the neighbor kids, and can be easily locked up. It will also give you an opportunity to actually plant in the ground if you desire, and this is the best way to avoid root-bound plants (if your not using hydroponics), and get bigger harvests.

In winter, indoor space is used to start new seedlings or cuttings to be placed outside in the spring, using natural sunlight to ripen the plants. This routine will provide at least 3 outdoor/greenhouse harvests per year. If more space is available to constantly be starting indoors and flowering 2nd harvest plants outdoors, harvests are possible every 60 days in many areas, with a small indoor harvest in the winter as a possibility as well. The basic strategy of year round production is to understand the plant has two growth cycles. At germination the plant enters into a vegetative state and will be able to use all the continuous light you can give it. This means there is no dark cycle required. The plant will photosynthesis constantly and grow faster than it would outdoors with long evenings. Photosynthesis stops during dark periods and the plant uses sugars produced to build during the evening. This is not a requirement and the plant will grow faster at this stage with continuous photosynthesis (constant light).

Once the plant is 12-18" tall, weather permitting, it can be forced to start flowering by placing it outside in the Spring or Fall. (For Summer outdoor flowering, the night must be artificially lengthened in the greenhouse to "force" the plants to flower. See FLOWERING chapter.) Moving the plants to 10-13 hour light periods (moving it outside) with uninterrupted darkness (no bright lights nearby) will force the plant to flower. It will ripen and be 2-3' when ready to harvest. When a plant is moved from continuous indoor light to a 10-13 hour day outside, it will start to flower in anticipation of oncoming winter. Vegetative starts moved outside March 1st, will be ripe by May 1. Vegetative starts moved outside on May 1 will be ripe by July 1. Starts moved outside Sept 1 are picked by Nov. 1st.

In Winter, operations are moved indoors and a cer last freezes are over. The space can be a closet, a section of a bedroom, a basement area, an attic or unused bathroom. Some people devote entire bedrooms to growing. The space must be light leak proofed, so that no suspicious light is seen from outside the house. This could invite fuzz or rip-offs. The space should be vented. Opening the door of a closet can be enough ventilation if the space is not lit by big lights that generate a lot of heat. Separate exhaust and incoming air vents are best. One at the top of the room to exhaust air into the attic or out the roof, and one to bring in air from an outside wall or under-floor crawl space. Use fans from old computer cabinets, available from electronic liquidators for $5 each. Dimmer swithes can be used to regulate the speed/noise of the fans. Use silicon to secure the fans to 4-6" PVC pipe pushed thru a round hole cut in the floor and ceilings. Use lots of silicon to damp the fans vibrations, so that the walls do not resonate to the fans' ocsilations. Line the walls with aluminum foil, dull side out to diffuse the light and prevent hot-spots, or paint the walls bright white to reflect light. Aluminized mylar, 1 mil thick is best.($20 for 25 feet of a 4' wide roll.)

Mirrors are not good to use, since the glass eats light! Line the floor with plastic in case of water spills, etc. Set up a voltage interrupt socket and be sure the electrical wiring will handle the lamps your going to use. Always place ballasts for HID lamps on a shelf, so they are above floor level, in case of water spills. Spacers place on the floor under a ballast will work too. A shelf above the main grow area can be used to clone cuttings and germinate seedlings. It will allow you to double the area of your grow space and is an invaluable storage area for plant food, spray bottles and other gardening supplies. This area stays very warm, and no germination warming pad will be needed, so this arrangement saves you $. Hang a light proof curtain to separate this shelf from the main area when used for flowering. This will allow constant lights on the shelf and dark periods in the main grow area. Velcro can be used to keep the curtain in place and ties can be used to roll it up when tending the garden. Black vinyl with white backing works best.

Now you need light. A couple of shop lights will be fine if you just want to start plants inside and then take them outside to grow in a small greenhouse. They can be purchased with bulbs for about $10 each, or without bulbs for around $8. Try to find them on sale. Use one Cool White and one Warm Light type bulb in each to get the best light spectrum possible for plant growth. Do not use expensive Grow Lux type bulbs, as they do not put out as much light, and therefor do not work as well in most situations (go figure). If Cool White is all you can find, or afford, use them.